SeaDoo GTI LE RFI Especificaciones descargar pdf (Pagina 88)

NOTE: Most of the antifreeze will

drain out when removing the hose

pinchers. Use a container to recover

it. DISPOSE ANTIFREEZE AS PER

YOUR LOCAL LAWS AND REGULA-

TIONS.

NOTE: Although antifreeze mainly

drained out, the antifreeze has mixed

with the water that was possibly

trapped in the water jackets. This will

prevent freezing problems.

At preseason preparation, drain the re-

maining antifreeze from cooling sys-

tem prior to using the watercraft.

The following steps should be per-

formed to provide the watercraft en-

hanced protection.

Clean the bilge with hot water and de-

tergent or with bilge cleaner. Rinse

thoroughly. Lift front end of water-

craft to completely drain bilge. If any

repairs are needed to body or to the

hull contact your authorized Sea-Doo

dealer. For paint touch up to mechan-

ical parts use BRP spray paint.

Reinstall vent tube support (if applica-

ble).

Anticorrosion Treatment

Wipe off any residual water in the en-

gine compartment.

Spray BOMBARDIER LUBE lubricant

or equivalent over metallic compo-

nents in engine compartment.



WARNING

Do not lubricate the safety lanyard

post.

Lubricate the throttle cable with BOM-

BARDIER LUBE lubricant or equiva-

lent.

Final Steps

Apply a good quality marine wax to the

body.

The seat and the seat extension (if

so equipped) should be partially left

opened and storage baskets (if so

equipped) should be removed dur-

ing storage. This will prevent engine

compartment condensation and pos-

sible corrosion.

Ifthewatercraftistobestoredout-

side, cover it with an opaque tarpaulin

to prevent sun rays and grime from af-

fecting the plastic components, water-

craft finish as well as preventing dust

accumulation.

CAUTION:

The watercraft should

never be left in water for storage.

Never leave the watercraft stored in

direct sunlight. Never completely

seal watercraft in a plastic wrap.

Ventilation must be provided to

avoid condensation and possible

corrosion.

Preseason Preparation

Use the following chart.

Since technical skills and special tools

are required, some operations should

be performed by an authorized Sea-

Doo dealer.



WARNING

Only perform procedures as de-

tailed in this guide. It is recom-

mended that the assistance of an

authorized Sea-Doo dealer be pe-

riodically obtained on other com-

ponents/ systems not covered in

this guide. Unless otherwise spec-

ified, engine must not be running

and the safety lanyard must be re-

moved from its post for all main-

tenance procedures. Components

inside engine compartment may

be hot. When component condi-

tions seem less than satisfactory,

replace with genuine BRP parts or

approved equivalents.

88

______________________

www.SeaDooManuals.net

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 120 121

Comentarios a estos manuales

Sin comentarios