SeaDoo GTX RFI Manual de usuario descargar pdf (Pagina 2)

Engine Removal / Installation

Sea-Doo 800 RFI

v 1.1 © 2006 Short Block Technologies

2

2.6 Remove the four 6mm allen head bolts

securing the throttle body.

2.7 (Below) There are two oil lines running

from the oil tank to the case and oil pump.

These provide oil to the oil bath inside the

case. Loosen the clamps and pull the lines

from the case. Don’t worry about spilled

oil, you will inevitably lose the oil in the

case. Zip-tie the two lines anywhere above

the tank level so the oil will not drain out.

Remove the oil injector lines going to the

rotary valve cover. Remove the four bolts

securing the cover. Remove it and the

rotary valve below.

2.8 (Below) Loosen the gas tank cap to

relieve pressure. Disconnect the fuel

supply line. Be aware of any fuel that may

spill from the hose. Make sure the hull is

clear of any gasoline fumes before

continuing work, especially with power

tools.

Step 3

Exhaust Removal

3.1 (Below) Loosen the clamp and

disengage the waterbox from the stinger

pipe.

3.2 (Below) Disconnect the waterlines

coming from the pipe and from the head.

Remove the clamp by loosening it with a

screw driver.

3.3 (Below) Remove the 13mm bolt from

the header pipe, and the two 13mm bolts

securing the brace to the flywheel housing.

Remove the brace. Disconnect the water

line from the header pipe.

1 2 3 4 5 6 7 8 9 10

Sea-Doo 800 RFI 1

Comentarios a estos manuales

Sin comentarios