SeaDoo GTX RFI Manual de usuario descargar pdf (Pagina 3)

Engine Removal / Installation

Sea-Doo 800 RFI

v 1.1 © 2006 Short Block Technologies

3

3.4 (Below) Remove the 13mm bolt from

the header pipe securing the pipe to the

case of the engine.

3.5 (Below) Remove the four 8mm Allen

bolts from the exhaust header pipe.

Loosen and remove the head pipe.

Remove the two water lines on the T-

fitting, found under the stinger pipe

mounting point.

Step 4

Engine Removal

4.1 Disconnect the flywheel electrical

harness using the quick connect.

Disconnect the crank position sensor using

a 10mm socket. NOTE: DO NOT CUT

THE WIRES.

4.2 (Below) Remove the two cooling lines

on the flywheel cover

4.3 (Below) Remove the ground cable from

the case using a 12mm socket.

4.4 (Below) Remove the two wing nuts and

remove the PTO flywheel shield.

4.5 (Below) Remove the front engine

mount bolt and two bolts securing the

mount to the hull with a 13mm socket.

4.6 (Below) Remove the starter wire with a

10mm socket.

1 2 3 4 5 6 7 8 9 10

Sea-Doo 800 RFI 1

Comentarios a estos manuales

Sin comentarios