
54
Out of Fuel
DI Models
When running the engine out of fuel,
it may be necessary to remove and in-
stall the safety lanyard 2-3 times to ini-
tially feed the fuel system after fuel
tank refill.
Towing the Watercraft in
Water
All Models
Special precautions should be taken
when towing a Sea-Doo watercraft in
water.
Maximum recommended towing speed
is 24 km/h (15 MPH).
When towing your watercraft in water,
pinch the water supply hose from the
impeller housing to the engine with a
large hose pincher (P/N 529 032 500).
This will prevent the cooling system
from filling which may lead to water be-
ing injected into and filling the exhaust
system. Without the engine running
there isn’t any exhaust pressure to car-
ry the water out the exhaust outlet.
CAUTION: Failure to do this may re-
sult in damage to the engine. If you
must tow a stranded watercraft in
water and do not have a hose pinch-
er, be sure to stay well below the
maximum towing speed of 24 km/h
(15 MPH).
Snugly install the hose pincher on the
water supply hose as shown.
CARBURETOR-EQUIPPED MODELS
1. Hose pincher on water supply hose on this
side of the T-fitting
DI MODELS
1. Hose pincher on water supply hose
CAUTION: When finished towing the
watercraft, hose pincher should be
removed before operating it. Failure
to do so will result in damage to the
engine.
Low-charge Battery
Condition
See an authorized Sea-Doo dealer to
have it charged or replaced.
F01B23Y
WARNING
Do not charge or boost the battery
while installed on the watercraft.
F12E01Y
1
F07E03Y
1
smo2000-003a.book Page 54 Thursday, November 11, 1999 10:44 AM
Comentarios a estos manuales