SeaDoo RX Instrucciones de operaciones Pagina 72
- Pagina / 91
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
70
TROUBLESHOOTING
The following chart is provided to help in diagnosing the probable source of simple
troubles. You may be able to solve many of these problems rather quickly, but
others may require the skills of a mechanical technician. In such cases, consult
an authorized Sea-Doo dealer for servicing.
Monitoring Beeper Coded Signals
CODED SIGNALS POSSIBLE CAUSE REMEDY
2 short beeps
(while installing safety
lanyard on switch).
• Confirms safety lanyard
signal operation.
Engine can be started.
1 long beep
(while installing safety
lanyard on watercraft
switch or when pressing
engine start/stop button).
• Safety lanyard on switch
for more than 10 minutes
without starting engine.
Apply a slight pressure or remove
and reinstall safety lanyard on
switch.
• Bad connection.
Reinstall safety lanyard cap correctly
over switch.
• Wrong safety lanyard.
Use a safety lanyard that has been
programmed for the watercraft.
• Defective safety lanyard.
Use another programmed safety
lanyard.
• Dried salt water in safety
lanyard cap.
Clean safety lanyard cap to remove
salt water.
• Improper operation of
MPEM or defective
wiring harness.
Refer to an authorized Sea-Doo
dealer.
A 2 seconds beep every
2 seconds intervals
(DI models).
• Exhaust system
overheat.
See engine OVERHEATING.
A 2 seconds beep every
minute intervals
(DI models).
• Fuel tank level is low.
Refill as soon as possible.
• Very low battery voltage.
Refer to an authorized Sea-Doo
dealer.
• Coolant and exhaust gas
temperature sensors or
TPS (throttle position
sensor) or CPS
(crankshaft position
sensor) malfunction.
Refer to an authorized Sea-Doo
dealer.
•MPEM malfunction.
Refer to an authorized Sea-Doo
dealer.
A 2 seconds beep every
15 minutes intervals
(DI models).
• Oil injection reservoir
level is low.
Refill.
8 short beeps (carburetor-
equipped models).
•Defective MPEM.
Refer to an authorized Sea-Doo
dealer.
Continuously beeps.
• Engine overheats.
See engine OVERHEATING.
smo2000-003a.book Page 70 Thursday, November 11, 1999 10:44 AM
www.SeaDooManuals.net
- Videocassette 3
- Operator’s Guide 3
- Safety Handbook 3
- Piloting 3
- TABLE OF CONTENTS 4
- FOREWORD 7
- SAFETY WARNING 8
- Maintenance 11
- LIST OF DISTRIBUTORS 12
- AMERICA: 2000 SEA-DOO 13
- WATERCRAFT 13
- WARRANTY: 2000 SEA-DOO 15
- REGISTRATION NUMBER LOCATION 17
- Label 1 Label 2 18
- DO NOT BOOST BATTERY 19
- WHILE INSTALLED 19
- IDENTIFICATION NUMBERS 20
- RX/DI Models 21
- GTX DI Models 22
- COMPONENTS FUNCTIONS 24
- 2) Handlebar 25
- 3) Throttle Lever 25
- 4) Engine Start/Stop 25
- All Models 26
- Carburetor-Equipped Models 26
- RX Models 26
- 1. Position indicator 28
- 2. Bow up 28
- 3. Bow down 28
- 10) Glove Box 30
- 11) Fuel Tank Valve 30
- 12) Fuel Tank Cap 30
- 13) Oil Injection Reservoir 30
- Step : Lift 31
- 1. Holder 31
- 19) Seat Latch 32
- 30) Flushing Connector 35
- 31) Bilge Drain Plugs 35
- 32) Jet Pump Nozzle 35
- 33) Reverse Gate 35
- 34) Jet Pump Water Intake 35
- FUEL AND LUBRICATION 36
- Oil Injection System 37
- BREAK-IN PERIOD 38
- DAILY PRE-OPERATION CHECKS 39
- 1. Inspect this area 40
- OPERATING INSTRUCTIONS 42
- 3. Nozzle up 44
- Boarding the Watercraft 45
- A. 90 cm (3 ft) 46
- Starting the Engine 47
- Rough Water or Poor 48
- Visibility Operation 48
- Crossing Waves 48
- Stopping/Docking 49
- Beaching 49
- Shutting Off the Engine 49
- POST-OPERATION CARE 50
- DI Models 51
- Anticorrosion Treatment 52
- SPECIAL PROCEDURES 53
- Capsized Watercraft 54
- Submerged Watercraft 54
- Water-Flooded Engine 54
- Fuel-Flooded Engine 55
- Out of Fuel 56
- Towing the Watercraft in 56
- Low-charge Battery 56
- Condition 56
- MAINTENANCE 57
- Periodic Inspection 58
- Periodic Inspection Chart 59
- WARNING 61
- VTS Adjustment 62
- (if so equipped) 62
- Vacuum Bailer Pick-Ups 62
- General Inspection and 64
- Cleaning 64
- TRAILERING, STORAGE 65
- AND PRE-SEASON PREPARATION 65
- 1. Bleed outlet hose 69
- 1. Engine drain hose 69
- 1. Water regulator valve 69
- 2. Supply hose 69
- Pre-Season Preparation 70
- Pre-Season Preparation Chart 71
- TROUBLESHOOTING 72
- Engine Will Not Start 73
- Engine Overheats 74
- Engine Continually Backfires 74
- Engine Pinging or Knocking 74
- SPECIFICATIONS 76
- SI* METRIC INFORMATION 80
- DEALER IMPRINT AREA 82
- CHANGE OF ADDRESS 83
Relacionado con productos y manuales para Motor SeaDoo RX
Motor SeaDoo GTI LE Manual de usuario
(22 paginas)
(22 paginas)
Motor SeaDoo GSI Instrucciones de operaciones
(105 paginas)
(105 paginas)
Motor SeaDoo GTX 4-TEC Instrucciones de operaciones
(104 paginas)
(104 paginas)
Motor SeaDoo GTI LE Especificaciones
(130 paginas)
(130 paginas)
Motor SeaDoo GS Instrucciones de operaciones
(109 paginas)
(109 paginas)
Motor SeaDoo GTI LE RFI Especificaciones
(121 paginas)
(121 paginas)
Motor SeaDoo GSX Limited Manual de usuario
(11 paginas)
(11 paginas)
Motor SeaDoo XP DI Instrucciones de operaciones
(24 paginas)
(24 paginas)
Motor SeaDoo SP Manual de servicio
(316 paginas)
(316 paginas)
Motor SeaDoo GS Instrucciones de operaciones
(100 paginas)
(100 paginas)
Motor SeaDoo GSX Manual de servicio
(56 paginas)
(56 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.050 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales